產品詳情 Product details

本機用于威蒂運輸機發生事故時緊急停機。

2.工作原理
當膠帶運輸現場發生緊急事故時?？衫瓌酉翟诶K開關吊耳上的鋼絲繩，使機內的滑塊控制內部微動開關動作，發出停機或警報信號。自動復位機型在松開鋼絲繩后自動復位，手動復位機型需操作復位手柄后方可復位。

3.使用與安裝
開關平衡地按在機架的固定支架上;
將鋼絲緝系在兩端的拉環上。每惻繩不超過30M{有坡度時應當縮短〕 ;
拉繩壓力應適宜，以確保開關可靠復位;
拉繩沿膠帶平行方向設置，每3M加一吊環;
銅絲繩按用戶所露規格,廠方可代購。

4.結構特點
本機采用鋁合金精密壓鑄殼體，強度離,重量輕;
外殼防護等級達IP67?？稍谙ち迎h境中長期工作;
機內采用進口元件。鮭點容量大。動作靈敏?？煽?。

5.主要技術參數

2.Working Principle

When there is an emergency at the tape transportation site , the steel wire rope attached to the rope switch liting ears can be pulled,so that the slider inslde the machine controls the internal micro switch to actuate and send out a shutdown or alarm signal. Theautomatic reset model will automatically reset after loosening the wire rope.The manual reset model can only be reset afteroperating the reset handle.

3.use & Installation
1.The switch is pressed on the fixed bracket of the rack in a
2.Tie the steel wire rope to the pull rings at both ends, and thebalanced manner.
ropeon each aide should not exceed 3OM(it should be
shortened when there is a sllope).
3.The pressure of the pull rope should be appropriate to ensurethe reliable reset of the switch.
4.The pull rope is se along the parallell direction of the tape, and5.The sfeel wire rope can be purchased according to thea lifting ring is added every 3M.
specifications required by the user.

4.Characteristics
1.Special aluminum alloy material, heat treatment processing.
strong moisture and corrosion resistance:
2.No jamming,no crash, no deformation, with wind and sandprevention, bird nest building and other functions;
3.Quick start,smooth operation, bright sound source , strong
penetration ,and large sound coverage

5.Technical Parameters